Classes

Another New Tool For Making Backsaws

One of the options I wanted to make available in preparation for the “Make a Petite Dovetail Saw” workshop was the ability to use a slotted brass spine for the backsaw.  To make the stock for this I ordered the brass bar stock and a 1/32″ slotting saw blade from McMaster Carr.

The issue I had to resolve was that the only slotting saw big enough to clear the table surface of one of my table saws from inventory had a 1″ arbor hole, while the shaft for the saw blade was only 1/2″ diameter.  I made a fitted spacer from a standard large washer to allow the blade to be used on the shaft, adding a pair of oversized collars on either side to keep everything lined up.

I then had to fabricate a jig to keep the bar stock in the correct relationship to the slotting saw blade in the table saw.  Again some stuff from the scrap shelf came in handy.  A piece of 1/4″ marine plywood served as the panel, with stops glued front and rear and another pair aligned with the miter-crosscut slots to keep the whole unit fixed in one place and one place only.  You can see this panel flipped over here.

With that finished I glued fences on both sides of the slotting saw blade to bisect the bar stock.  It worked like a charm provided I take three light and gentle passes through the saw.

I can now produce as much slotted spine stock as I want.