Musings

Excising Gobs of Mass, aka Fancyin’ Up the Roubo Bowsaw Prototype

With Roubo Joinery Bowsaw Prototype tested in battle and found wanting in the lightness department, it was time to think about ways to reduce the overall weight and bring that down to a point I was comfortable with.  As it was now, it was a massive beast that was simply too heavy to use as a one-handed saw for cutting tenons or dovetails.

I rounded all the edges substantially, but that was not enough weight reduction.

I sculpted the tops of the arms, it was pretty but insufficient.

I transformed the stout cross-bar into a diamond cross-section with tapered chamfers providing the transitions.  Nyet.

It wasn’t just a smidge heavy, it was a couple pounds too heavy.  Achieving any more mass reductions would have been quicker with a new starting point since I had obviously selected the wrong one here.  Since Bad Axe had sent me some new plates to my specs, that’s where I went next.  We’ll see if 3/4″ white oak stock is up to the task of restraining these plates, or if I need to address this frame again with acres of carving and other diminutions.  At the very least, with 3/4″ stock I would start with a 40% reduction in weight, so the idea was promising.

Stay tuned.