Writing Desk – Polishing and Assembly
Once the finishing process was essentially complete it was time to rub out the surfaces and glue-up the desk. Since my goal for the surface was to present an unfilled, lightly-worn, ancient-but-well-cared-for appearance and character I rubbed down all the surfaces to accomplish those ends.
My typical procedure for this undertaking is to abrade the surface with ultra-fine steel wool saturated with paste wax or conversely a 4F pumice/paste wax blend, incorporating or succeeded by the inclusion of tripoli/rottenstone to leave subtle traces of “ancient schmutz” in the crevices.
In this instance I mixed up a paste wax/rottenstone blend to use with the steel wool, and proceeded to rub every exposed surface until the outcome arrived at the destination I was aiming for.
The “glow” and subtle grain of the resultant surface was so glorious I had to just look at it for a while.
This comparison of a rubbed-out (L) vs. raw surface (R) is demonstrative of the transformation.
This is the address I was looking for.
With the finishing mostly done I glued everything together with hide glue, and suddenly there was a complete piece of furniture staring me straight in the eye. There were only a couple of final steps to take, applying another round of pad finishing to the writing surface before rubbing that out, and buffing off the rottenstone-laced dried paste wax.
Join the Conversation!